TYT Radios

Setting up a Backyard Repeater using AllStarLink with the HamVOiP/ASL3 software, a TYT 9000d radio, and the RIM-Alinco FOB and Alinco DR-x38 Series Rear Connector Cable. That is a lot of terms, but I will explain below.

Step 1: If you do not already have a DMR ID, you need to have one. Go to Radioid.net and sign up.

Step 2: You will need to obtain a node number at AllStarLink. Go to AllStarLink.org and sign up.

Make sure to bookmark this site; you will be going back to this site a lot. Take time to read the information on the site; it helps you understand what an AllStar server is and how the node system works.

Step 3: Go to HamVoIP and download the latest version of the HAMVoIP image, which was version 1.7-01 when this How-To-Document was developed: HamVOiP Image. We would also encourage you to review the other links on the HAMVoIP Homepage.

Step 4: You will need a Raspberry Pi model 3 or model 4b. There are many places to buy these boards, but I have bought many from Vilros. I would also recommend a Pi 4 with 1GB. You can go to Vilros at Raspberry Pi 4B and get a Pi4B with 1 GB for about $35. However, you might want to consider a kit to ensure you have a power supply and a case. They have basic starter kits as well as complete starter kits. It takes some time to look around or find another site that may have better prices. As always, ask for help if you are unsure which way to go.

Step 5: At this point, you also need to get at least one micro-SD card. I would recommend 32GB, much more than you will need, but as you grow, it is good to have the space. They can be bought just about anywhere, but as a starting point, take a look at Amazon. These little SD cards get a workout, so ensure you get something sturdy.

Step 6: You will also need a TYT TH-9000d (VHS or UHF). There are many places to get these radios, but we have had good luck with Amazon. Check here: TYT TH-9000d. The cost at the time of this document was $127.90 for a VHS radio.